Legacy Data System Reference - Comtech EF Data

Legacy Data
1.3 Configuring an HDLC Connection
The PORT or SLOT submenu of the SETUP console command includes all parameters
required to configure an HDLC port.
If you are using SNMP, the required configuration variables are grouped under the ifwan
category. For text-based configuration the [ifwan#] heading is used, where # represents
the number of the port or channel.
An HDLC port can be configured on a serial port (including ports built into the base unit
and ports on the Dual Serial Port interface card) or a channel on a digital interface card.
• To configure a built-in serial port on the base unit as an HDLC port:
- Enter the menu sequence: SE � PORT.
- Select the Port number.
- Set the Protocol to HDLC.
- Change the other port parameters from their default values, if desired.
• To configure a digital channel or a serial port on the Dual Serial interface card as
an HDLC port:
- Enter the menu sequence: SE � SLOT.
- Select the Slot number.
- On a digital interface card only: enter CHANNEL at the Item prompt.
- Select the Channel number, e.g. 102, where the first digit indicates the slot
and the last two digits indicate the channel.
- Set the Protocol to HDLC.
- Change the other channel parameters from their default values, if desired.
1.3.1 HDLC Port Configuration
Console SNMP Text-based Config
SE/PORT (serial port)
SE/SLOT (digital channel
or dual serial port)
ifwan (category) [ifwan#] (heading)
When you define a serial port as HDLC, the following port parameters are listed on the
console:
SE/PORT/#/
HDLC example SDM-9230>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/USER/VLAN,
def:BRIDGE) ? PORT
Port number (ETH1/ETH2/CSL/1,def:1) ?
1-4 Memotec Inc.