Legacy Data System Reference - Comtech EF Data

• Idle:FLAG
• Frame Delay:0.0
9.2 Configuring an X25 Port
X.25 Protocol
The PORT or SLOT submenu of the SETUP console command includes all parameters
required to configure an X25 port.
If you are using SNMP, the required configuration variables are grouped under the ifwan
category. For text-based configuration the [ifwan#] heading is used, where # represents
the number of the port or channel.
An X25 port can be configured on a built-in serial port or a serial port on a Dual Serial
Port interface card.
• To configure a built-in serial port on the base unit as an X25 port:
- Enter the menu sequence: SE � PORT.
- Select the Port number.
- Set the Protocol to X25.
- Change the other port parameters from their default values, if desired.
• To configure a serial port on the Dual Serial interface card as an X25 port:
- Enter the menu sequence: SE � SLOT.
- Select the Slot number.
- Select the Channel number, e.g. 102, where the first digit indicates the slot
and the last two digits indicate the channel.
- Set the Protocol to X25.
- Change the other parameters from their default values, if desired.
9.2.1 X25 on a built-in Serial Port
Console SNMP Text-based Config
SE/PORT (serial port)
SE/SLOT (digital channel
or dual serial port)
ifwan (category) [ifwan#] (heading)
When you define a built-in serial port with the X25 protocol, the following port
parameters are listed on the console:
SE/PORT/#/
X25 example SDM-9230>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
Memotec Inc. 9-3