Legacy Data System Reference - Comtech EF Data

More documents

Recommendations

Info

Protocol spoofing 6-3 PU command 6-11 PU number 13-2 PUs activation status 13-3 BAN destination address 13-15 BAN routing 13-18 BAN/BNN destination SAP 13-16 BAN/BNN dynamic window 13-17 BAN/BNN frame size 13-18 BAN/BNN retransmission timeout 13-16 BAN/BNN retries 13-16 BAN/BNN source SAP 13-15 BAN/BNN window 13-17 BNN FID type 13-19 BNN PVC number 13-19 class 13-8 delay before connection 13-3 destination SAP 13-10 exchange identification 13-6, 13-12 ID block 13-13 ID number 13-13 incrementing transmission window size 13-11 LLC destination address 13-9 LLC timeout 13-10 maximum frame size 13-7, 13-12 number of retries 13-5, 13-11 on remote unit 13-8 operating mode 6-3, 13-2 parameters, configuration of 6-11, 13-3 primary address 13-4 primary port connection 13-4 SDLC address 13-7 SDLC timeout 13-5 secondary address 13-5 secondary port connection 13-4 SNA/SDLC port connection 13-7 source SAP 13-9 transmission window size 13-6, 13-11 type in XID 13-14 verifying active 11-12 XID type 13-13 PVC number for BNN connection 13-19 on HDLCOFR port 12-13 R Reception flow control 12-16 Remote port specifying 12-11 Remote port number 12-11 Remote PU 13-8 Remote PU number 13-8 Remote Unit defining 13-8 Remote unit 12-10, 13-8 Retransmission timeout for BAN/BNN connection 13-16 Retries for BAN/BNN connection 13-16 RIF caching 6-5 Role for LLC and BAN/BNN 13-20 Routed SNA Over Frame Relay 6-4 Router IPX 14-4 Routing IPX 14-3 IPX RIP 14-2 IPX SAP 14-2 Routing for BAN connection 13-18 Routing table age of entry 15-3, 15-5 hop count, IPX 15-2, 15-4 NET NUM, IPX 15-3 network number, IPX 15-2 next hop, IPX 15-2 node, IPX 15-3 service name, IPX 15-4 service type, IPX 15-4 socket, IPX 15-3 ticks, IPX 15-2 RTS signal operating mode 12-7 4 Memotec Inc. S SAP value to be filtered 14-7 SAP for IPX filter 14-7 SAP mapping 6-4 SDLC address 13-7 of PU 13-7 SDLC driver 6-2 concentration 6-4 multipoint connection 6-3 SDLC duplex mode 12-17 SDLC Frame Size 13-12 SDLC frame size 13-7 SDLC number of retransmission retries 13-5 SDLC port 13-7 SDLC primary address 13-4 SDLC primary port 13-4 SDLC retransmission timeout 13-5 SDLC secondary address 13-5 SDLC secondary port 13-4 SDLC transmission window size 13-6 SDLC-SDLC mode of PU 6-3, 13-2 Secondary address of PU 13-5 Secondary port 6-2
PU connection 13-4 SERVICE NAME displaying for IPX routing table 15-4 Setup IPX menu 10-4 Setup Port menu 6-8 Setup PU menu 6-11 Single switch conversion 6-5 advantages 6-6 SNA data 6-3 SNA Over Frame Relay 6-5 SNA Over RFC-1490 6-4 SNA/SDLC port connection, of PU 13-7 duplex mode 12-17 group address 12-17 group poll 12-17 poll delay 12-18 SOCKET displaying for IPX routing table 15-3 Source SAP of PU 13-9 Source SAP for BAN/BNN connection 13-15 Statistic HOP COUNT, displaying for IPX routing table 15-4 NET NUM, displaying for IPX routing table 15-3 NODE, displaying for IPX routing table 15-3 SERVICE NAME, displaying for IPX routing table 15-4 SOCKET, displaying for IPX routing table 15-3 TYPE, displaying for IPX routing table 15-4 Statistics AGE, displaying for IPX routing table 15-2, 15-5 HOP COUNT, displaying for IPX routing table 15-2 IPX routing table 10-6 NETWORK NUMBER, displaying for IPX routing table 15-2 NEXT HOP, displaying for IPX routing table 15- 2 TICKS, displaying for IPX routing table 15-2 Subchannel mask 12-11 Subchanneling 12-11 Suppress DM upon disconnection 13-6 Synchronization character 12-19 T TICKS displaying for IPX routing table 15-2 Timeout SDLC 13-5 Transmission flow control 12-16 Transmission start level 12-6 Transmission window size dynamic 13-11 for PU 13-6, 13-11 incrementing 13-11 Transmit holding time 12-16 Transmitter idle state 12-9 Tx/Rx mode on HDLCOFR port 12-13 TYPE displaying for IPX routing table 15-4 Type IPX filter 14-8 Type of IPX filter 14-8 <strong>Legacy</strong> <strong>Data</strong> 5 U Underruns 12-6 preventing 12-6 W WAN/User ports protocol 12-2 Window for BAN/BNN connection 13-17 X X.25 protocol application example 9-5 configuration of 9-4 encapsulation method 12-21 encapsulation to Frame Relay 9-2 HDLC driver 1-3 X25 frame relay encapsulation 12-21 XID manual setting 13-12 XID format 13-13 XID identification number 13-13 XID PU type 13-14 XID support 13-6, 13-12 XID type for PU 13-13
Page 1 and 2:
Legacy Data NetPerformer ® System
Page 3 and 4:
Contents Chapter 1: HDLC Protocol .
Page 5 and 6:
8.1.2 Transmission:. . . . . . . .
Page 7 and 8:
12.10.1 X25 frame relay encapsulati
Page 9 and 10:
15.1.9 NODE. . . . . . . . . . . .
Page 11 and 12:
HDLC Protocol 1 Memotec Inc. 1-1
Page 13 and 14:
1.2 NetPerformer Support of HDLC HD
Page 15 and 16:
HDLC Protocol PORT 1> Protocol (def
Page 17 and 18:
HDLCOFR Protocol 2 Memotec Inc. 2-1
Page 19 and 20:
PASSTHRU Protocol 3 Memotec Inc. 3-
Page 21 and 22:
3.3 Configuring a PASSTHRU Connecti
Page 23 and 24:
PASSTHRUOFR Protocol 4 Memotec Inc.
Page 25 and 26:
4.1.1 Number of Digital PASSTHRUOFR
Page 27 and 28:
PASSTHRUOFR Protocol 4.3 Configurin
Page 29 and 30:
SE/SLOT/#/ CHANNEL/ PASSTHRUOF R ex
Page 31 and 32:
Asynchronous Protocols 5 Memotec In
Page 33 and 34:
Asynchronous Protocols 5.4 Configur
Page 35 and 36:
SE/PORT/#/R- ASYNC example SE/SLOT/
Page 37 and 38:
SNA/SDLC Support 6 Memotec Inc. 6-1
Page 39 and 40:
SNA/SDLC Support • SNA/SDLC port
Page 41 and 42:
SNA/SDLC Support representing the s
Page 43 and 44:
SNA/SDLC Support routes SNA to the
Page 45 and 46:
SNA/SDLC Support PHONE/ PORT/PU/PPP
Page 47 and 48:
6.3 Configuring a PU SNA/SDLC Suppo
Page 49 and 50:
PU 1> LLC frame size (def:512) ? PU
Page 51 and 52:
6.3.6 Configuring a Non-SDLC PU Con
Page 53 and 54:
BSC Protocol 7 Memotec Inc. 7-1
Page 55 and 56:
BSC Protocol At the remote end, the
Page 57 and 58:
COP Protocol 8 Memotec Inc. 8-1
Page 59 and 60:
8.2 Configuring a COP Connection CO
Page 61 and 62:
X.25 Protocol 9 Memotec Inc. 9-1
Page 63 and 64:
• Idle:FLAG • Frame Delay:0.0 9
Page 65 and 66:
9.3 X.25 Application Example X.25 H
Page 67 and 68:
IPX Connections 10 Memotec Inc. 10-
Page 69 and 70:
10.2 Configuring an IPX Connection
Page 71 and 72:
IPX Connections The six IP submenus
Page 73 and 74:
10.3.2 IPX SAP Routing Table DR/IPX
Page 75 and 76:
Monitoring Data Port Functions 11 M
Page 77 and 78:
11.2 Display Counters (DC) DC/PORT
Page 79 and 80:
11.3 Display States (DS) DS/PORT ex
Page 81 and 82:
11.4 Display Port States (DPORT) DP
Page 83 and 84:
DE/PU example Monitoring Data Port
Page 85 and 86:
11.7 Display Parameters (DP) DP/SLO
Page 87 and 88:
SE/PORT Configuration Parameters 12
Page 89 and 90:
12.1.2 Port speed (bps) 12.1.3 Cloc
Page 91 and 92:
12.2 HDLC and PASSTHRU Ports 12.2.1
Page 93 and 94:
12.2.3 Modem control signal SE/PORT
Page 95 and 96: 12.2.4 Frame delay (ms) 12.2.5 CRC
Page 97 and 98: 12.2.9 Remote port number 12.2.10 S
Page 99 and 100: 12.3 HDLCOFR Port 12.3.1 Tx/Rx mode
Page 101 and 102: 12.6 T-ASYNC Port 12.6.1 Format SE/
Page 103 and 104: 12.8 P-SDLC Port 12.8.1 SDLC duplex
Page 105 and 106: 12.9 COP Port 12.9.1 Synchronizatio
Page 107 and 108: 12.10 X25 Port 12.10.1 X25 frame re
Page 109 and 110: SE/PU Configuration Parameters 13 M
Page 111 and 112: 13.1.3 Controller active SE/PU Conf
Page 113 and 114: 13.1.8 SDLC secondary address SE/PU
Page 115 and 116: 13.2 SDLC-LINKS Mode 13.2.1 SDLC po
Page 117 and 118: 13.3 SDLC-LLC Mode 13.3.1 LLC lan p
Page 119 and 120: 13.3.6 LLC maximum successive retri
Page 121 and 122: SE/PU Configuration Parameters The
Page 123 and 124: 13.4 SDLC-BAN Mode 13.4.1 BAN desti
Page 125 and 126: 13.4.6 BAN/BNN transmission window
Page 127 and 128: 13.5 SDLC-BNN Mode 13.5.1 BNN PVC n
Page 129 and 130: SE/IPX Configuration Parameters 14
Page 131 and 132: 14.1.3 IPX network number 14.1.4 IP
Page 133 and 134: Net1 Ethernet RT1 PVCR or FW SE/IPX
Page 135 and 136: 14.3 SE/IPX/FILTER Parameters 14.3.
Page 137 and 138: IPX Display Command Statistics 15 M
Page 139 and 140: 15.1.7 DR/IPX/SAP 15.1.8 NET NUM 15
Page 141 and 142: 15.1.14 AGE Console SNMP AGE (use p
Page 143 and 144: Index A Activation status of PU 13-
Page 145: O Operating mode of PU 13-2 P Param
show all

Legacy Data System Reference - Comtech EF Data

Create successful ePaper yourself

Delete template?

Save as template?