Legacy Data System Reference - Comtech EF Data

Legacy Data
SE/SLOT/
Channel/T-
ASYNC
example
5.4.2 R-ASYNC Connection
PORT 1> Remote unit (def:) ? CHICAGO-9230
PORT 1> Class (def:3) ?
PORT 1> Remote port number (1-65534,def:1) ?
• Protocol, Interface, Clocking mode, Port speed (bps), Modem control signal,
Remote unit, Class and Remote port number are common to other legacy data
port protocols. For details, go to “SE/PORT Configuration Parameters” on
page 12-1.
• The Format parameter is unique to the asynchronous protocols, and is detailed in
the section “T-ASYNC Port” on page 12-15.
SDM-9230>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/USER/VLAN,
def:BRIDGE) ? SLOT
SLOT> Slot number (1/2/3,def:2) ?
SLOT> Channel Number (201-202/ALL,def:201) ? 202
PORT 202> Protocol (def:R-ASYNC) ? T-ASYNC
PORT 202> Interface.............................DTE-V35
PORT 202> Clocking mode (def:ASYNC) ?
PORT 202> Port speed (bps) (300-115200,def:56000) ?
PORT 202> Format (def:8-NONE) ?
PORT 202> Modem control signal (def:STATIC) ?
PORT 202> Remote unit (def:) ?
PORT 202> Class (def:3) ?
PORT 202> Remote port number (1-65534,def:202) ?
• These are the same parameters as for T-ASYNC on a built-in serial port.
The PORT or SLOT submenu of the SETUP console command includes all parameters
required to configure an R-ASYNC port.
If you are using SNMP, the required configuration variables are grouped under the ifwan
category. For text-based configuration the [ifwan#] heading is used, where # represents
the number of the port or channel.
Console SNMP Text-based Config
SE/PORT (serial port)
SE/SLOT (digital channel
or dual serial port)
ifwan (category) [ifwan#] (heading)
An R-ASYNC port can be configured on a built-in serial port or a serial port on a Dual
Serial Port interface card.
• To configure a built-in serial port on the base unit as an R-ASYNC port:
5-4 Memotec Inc.