Legacy Data System Reference - Comtech EF Data

Legacy Data
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/USER/VLAN,
def:BRIDGE) ? PORT
Port number (ETH1/ETH2/CSL/1,def:CSL) ? 1
PORT 1> Protocol (def:PVCR) ? BSC
PORT 1> Interface...............................DCE-V35
PORT 1> Clocking mode (def:INTERNAL) ?
PORT 1> Port speed (bps) (1200-64000,def:56000) ?
PORT 1> Fallback speed (def:ENABLE) ?
PORT 1> Modem control signal (def:STATIC) ?
PORT 1> Transmission start level (def:AUTO) ?
PORT 1> Remote unit (def:) ? CHICAGO-9230
PORT 1> Class (def:3) ?
PORT 1> Remote port number (1-65534,def:1) ?
• All of these parameters are common to other legacy protocols, and are detailed in
“SE/PORT Configuration Parameters” on page 12-1.
7.3.2 BSC on the Dual Serial Interface Card
SE/SLOT/
Channel/BSC
example
When you define a serial port on a Dual Serial interface card with the BSC protocol, the
following parameters are listed on the console:
SDM-9230>SE
SETUP
Item (BRIDGE/CALLER ID/CLASS/CUSTOM/FILTER/GLOBAL/HUNT/IP/IPX/MAP/
PHONE/
PORT/PU/PPPOE/PPPUSER/PVC/REDUNDANCY/SCHEDULE/SLOT/USER/VLAN,
def:BRIDGE) ? SLOT
SLOT> Slot number (1/2/3,def:2) ?
SLOT> Channel Number (201-202/ALL,def:201) ?
PORT 201> Protocol (def:OFF) ? BSC
PORT 201> Interface.............................DCE-V35
PORT 201> Clocking mode (def:INTERNAL) ?
PORT 201> Port speed (bps) (1200-64000,def:56000) ?
PORT 201> Fallback speed (def:ENABLE) ?
PORT 201> Modem control signal (def:STATIC) ?
PORT 201> Transmission start level (def:AUTO) ?
PORT 201> Remote unit (def:) ?
PORT 201> Class (def:3) ?
PORT 201> Remote port number (1-65534,def:201) ?
• These are the same parameters as those for a built-in serial port.
Caution: The Dual Serial interface card for the SDM-9360, SDM-9380 and
SDM-9585 does not support Fallback.
7-4 Memotec Inc.