ERECTION AND SAFETY MANUAL - Rigid Global Buildings

ERECTION AND SAFETY MANUAL
4.2 RECOMMENDED TOOLS
When buying tools for building erection, it is recommended that only industrial rated, top
quality tools be purchased. Experience shows that lighter duty tools, although cheaper initially, will not hold
up satisfactorily, and in the long run, will cost more, not only in repairs, but also in lost time. High speed drill
bits are always recommended since carbon steel bits will not give satisfactory service. Most erectors fi nd that
short jobbers length bits are more economical and rugged than standard length bits.
The smaller hand tools are particularly diffi cult to maintain because of breakage, losses,
pilferage, etc. Some erectors require the workers on the crew to furnish their own tools in this category. Others
issue the tools to individuals or foremen who are held responsible and liable for them. Since work rules
and customs differ according to localities, each erector should establish a defi nite policy which is acceptable
to his workers while protecting his property.
Maintaining equipment and tools in safe clean fi rst class condition reduces injuries, lowers replacement expense,
and stimulates workers to take better care of equipment and greater pride in their work.
NOTE:
Make certain that the correct tool is available and used for each phase of building
erection. Improper tool usage results in employee injury.All tools should be OSHA
approved for commercial construction use.
Safety fi rst!!
Technical information contained herein is subject to change without notice. Page 7.1-17
Revision: 2
April 2011