ERECTION AND SAFETY MANUAL - Rigid Global Buildings
ERECTION AND SAFETY MANUAL - Rigid Global Buildings
ERECTION AND SAFETY MANUAL - Rigid Global Buildings
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.9 ROOF INSULATION<br />
Page 7.1-54<br />
Revision: 2<br />
August 2011<br />
<strong>ERECTION</strong> <strong>AND</strong> <strong>SAFETY</strong> <strong>MANUAL</strong><br />
Pre-cut roof insulation to reach from eave to eave allowing approximately 2 feet of additional length to facilitate<br />
handling. Hold Insulation at one sidewall and roll out insulation across the purlins, vapor barrier to the<br />
inside of the building. Stretch the Insulation to provide a tIght and smooth inside surface. Weights clamped<br />
to each end can be used to hold insulation taut.<br />
NOTE:<br />
Insulation has no load bearing strength. Maintain body weight on approved scaffold or walk<br />
boards. Follow all OSHA recommended safety instructions regarding safety harnesses and/or<br />
nets to protect from falls! Safety fi rst!<br />
Technical information contained herein is subject to change without notice.