ERECTION AND SAFETY MANUAL - Rigid Global Buildings
ERECTION AND SAFETY MANUAL - Rigid Global Buildings
ERECTION AND SAFETY MANUAL - Rigid Global Buildings
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.4 “AW” PANEL<br />
Page 7.1-46<br />
Revision: 2<br />
August 2011<br />
<strong>ERECTION</strong> <strong>AND</strong> <strong>SAFETY</strong> <strong>MANUAL</strong><br />
The “AW” panels are designed for wall applications only. The inverted ribs incorporated into its design produce<br />
smooth shadow lines and semi-concealed fasteners. Sheeting can begin from either end of the building, and<br />
application of the architectural panel is not directional. Properly installed, the lap edges of the “AW” panel will<br />
have minimum visibility.<br />
NOTE:<br />
The “AW” adversely affected by an uneven girt line, and I or insulation that causes an uneven girt line. Either<br />
situation could cause oil canning in the panels.<br />
The design of the panel lap allows for the panel edge to be visible when installed. Equipment limitations and<br />
manufacturing tolerances, as well as other factors can contribute to waviness at the visible edge.<br />
12"<br />
6" 6"<br />
NOTE:<br />
Do not apply pressure to the pan of the panels during installation, when the pressure is released,<br />
“oil canning” will occur. <strong>SAFETY</strong> FIRST!<br />
36"<br />
PANEL LAP<br />
1 1 4"<br />
Technical information contained herein is subject to change without notice.