DCC 6526L/6626L - TA Triumph-Adler GmbH

Symptom Checkpoints Corrective Actions
Printouts have black
lines.
10-5
Troubleshooting
Is the slit glass dirty? Clean the slit glass. 9-2
— Run [LaserScanner Cln]. 8-112
— Run [Drum Refresh]. 8-113
Grey background — Conduct color calibration either by
switching the machine off then on
or using the operation panel.
Dirt on the top edge or
back of the paper
Is the paper transfer unit
dirty?
8-103
Clean the transfer unit. 9-3
Offset occures. — Run [Drum Refresh]. 8-113
Part of the image is
periodically faint or
blurred.
— Run [MC] and increase the
adjustment value. Increase the
adjustment value 1 level at a time
from the current value. If there is
no improvement after the value is
increased by 1 level, increase by 1
level again. If there is still no
improvement, return the setting to
the original value.
— Run [MC] and decrease the
adjustment value. Decrease the
adjustment value 1 level at a time
from the current value. If there is
no improvement after the value is
decreased by 1 level, decrease by
1 level again. If there is still no
improvement, return the setting to
the original value.
Reference
Page
8-115
8-115
10