DCC 6526L/6626L - TA Triumph-Adler GmbH

Use the procedure below to setup the TCP/IP (IPv4) setting.
Login User Name: L b
********************
Login Password:
[ Login ]
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
3 System
[ Exit ]
Administrator only.
System: a b
*********************
1 Network Setting
2 I/F Block Set.
3 Security Level
[ Exit ]
Network Setting: a b
*********************
1 TCP/IP Settings
2 NetWare
3 AppleTalk
[ Exit ]
2-17
Preparation before Use
1 Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in.
NOTE: Refer to Character Entry Method on
Appendix-8 for details on entering characters.
2 In the Sys. Menu/Count. menu, press the or
key to select [System], and then press the OK key.
IMPORTANT: To make the settings, you must have
logged in using a Login User Name with administrator
privileges.
The default settings of the Login User Name and Login
Password are both "2600".
If you have logged in using a Login User Name without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
3 In the System menu, press the or key to
select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the or key to select [TCP/IP Settings].
2