Download the ST9340 Printer Reference Guide

Using the Print and Hold function
Make changes in the Local Printer Setup Utility to create settings that will apply to all print jobs. To
change settings for an individual print job, make selections using the printer driver. These settings
override settings made in the Local Printer Setup Utility.
The Local Printer Setup Utility lets you set values for the following settings:
Paper Settings
Paper Source
Paper Size (per supported sources)
Paper Type (per supported sources)
Custom Types (per custom type number)
Substitute Size
Configure MP
Paper Texture (per supported media)
Paper Weight (per supported media)
Paper Loading (per supported media)
PostScript Settings
Print PS Error
Font Priority
Setup Settings
Printer Language
Power Saver
Resource Save
Download Target
Print Timeout
Wait Timeout
Auto Continue
Jam Recovery
Page Protect
Print Area
Display Language
Alarm Control
Toner Alarm
Quality Settings
Print Resolution
Toner Darkness
PictureGrade
Finishing Settings
Duplex
Duplex Bind
Copies
Blank Pages
Collation
Separator Sheets
Separator Source
Multipage Print
Multipage Order
Multipage View
Multipage Border
Parallel Settings
PCL SmartSwitch
PS SmartSwitch
Parallel Buffer
Advanced Status
Honor Init
Using the Print and Hold function
PCL Emulation Settings
Orientation
Lines Per Page
A4 Width
Tray Renumber (per
supported sources)
Auto CR after LF
Auto LF after CR
USB Settings
PCL SmartSwitch
PS SmartSwitch
USB Buffer
When sending a job to the printer, you can specify in the driver that you want the printer to hold the
job in memory. When you are ready to print the job, you must go to the printer and use the operator
181