2 - Pitney Bowes Canada

Manual and automatic fax Redial
If you are sending a fax manually and the line is busy, press
Redial/Pause, and then press Start to try again. If you want to
make a second call to the last number dialed, you can save time by
pressing Redial/Pause and Start.
Redial/Pause only works if you dialed from the control panel.
If you are sending a fax automatically and the line is busy, the
machine will automatically redial one time after five minutes.
Dual Access
You can dial a number, and begin scanning the fax into memory—
even when the machine is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
If you get an Out of Memory message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get an
Out of Memory message while scanning a subsequent page,
you can press Start to send the pages scanned so far, or press
Stop/Exit to cancel the operation.
1 If it is not illuminated in green, press (Fax). Load the
original document.
2 Enter the fax number.
3 Press Start to send the fax.
The machine starts scanning the first page and the LCD shows
the job number (#XXX) of the fax. You can repeat Steps 1 to 3
for the next fax.
SETUP SEND 6 - 7