Masoneilan Products SVI II ESD - GE Energy
Masoneilan Products SVI II ESD - GE Energy
Masoneilan Products SVI II ESD - GE Energy
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>GE</strong> <strong>Energy</strong><br />
<strong>SVI</strong> <strong>II</strong> <strong>ESD</strong> Quick Start<br />
Table 4 Pneumatic Connections and Air Supply Requirements<br />
Recommended<br />
Piping Inlet/Outlet<br />
Instrument Air<br />
Pressure<br />
Dew Point<br />
Particulate Matter<br />
Oil Content<br />
Contaminants<br />
1/2” stainless steel or PVC tubing. The length of tubing between the<br />
<strong>SVI</strong> <strong>II</strong> <strong>ESD</strong> and the valve must be kept as short as possible and free<br />
of kinks<br />
30 - 120 psi (2.07 - 8.27 bar) (207 - 827 kPa)<br />
At least 18° F (10° C) below minimum anticipated ambient<br />
temperature<br />
Filtered to 5 microns<br />
Less than 1 ppm w/w<br />
Free of all corrosive contaminants<br />
Pneumatic Connections/Air Supply Requirements<br />
Single Acting PST Controller<br />
WARNING<br />
Isolate the valve from the process and disconnect air tubing<br />
from the PST Controller. Disconnect air fully to avoid injury or<br />
process damage.<br />
The supply and output connections for the <strong>SVI</strong> <strong>II</strong> <strong>ESD</strong>, located on bottom of the<br />
pneumatic block, are 1⁄4" NPT threaded. Output is toward the front, supply is<br />
toward the back.<br />
Maximum allowable air supply pressure to the <strong>SVI</strong> <strong>II</strong> <strong>ESD</strong> varies according to<br />
actuator, valve size, and valve type. Refer to the serial plate of the valve to know<br />
the specified supply pressure; it must never be less than the maximum spring<br />
pressure +10 psi.<br />
1. Install the tubing to the air supply port (S).<br />
2. For a single acting actuator - pipe the outbound air from the output pressure<br />
port (I) to the actuator.<br />
3. Air supply:<br />
Supply pressure for single acting <strong>SVI</strong> <strong>II</strong> <strong>ESD</strong>: <br />
30 -120 psi (2.07 - 8.28 bar) (207- 827.6 kPa)<br />
Minimum tubing diameter 1⁄4" (6 mmx4 mm)<br />
28
Change language