CLM HD8 - Projector Central
CLM HD8 - Projector Central
CLM HD8 - Projector Central
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
15. Maintenance<br />
15. MAINTENANCE<br />
About this chapter<br />
This chapter contains detailed maintenance procedures like lens cleaning, etc. These procedures can easily be performed by the<br />
operator of the projector.<br />
Overview<br />
• Cleaning the lens<br />
• Cleaning the exterior of the projector<br />
• Level check of cooling liquid<br />
15.1 Cleaning the lens<br />
To minimize the possibility of damage to optical coatings, or scratches to lens surfaces, we have developed<br />
recommendations for cleaning. FIRST, we recommend you try to remove any material from the lens by blowing<br />
it off with clean, dry deionized air. DO NOT use any liquid to clean the lenses.<br />
Necessary tools<br />
Toraysee TM cloth (delivered together with the lens kit). Order number : R379058.<br />
Howtocleanthelens?<br />
1. Always wipe lenses with a CLEAN Toraysee TM cloth.<br />
2. Wipe lenses in a one single direction.<br />
Warning: Do not wipe back and forwards across the lens surface as this tends to grind dirt into the coating.<br />
3. Do not leave the cleaning cloth in either an open room or lab coat pocket, as doing so can contaminate the cloth.<br />
4. If smears occur when cleaning lenses, replace the cloth. Smears are the first indication of a dirty cloth.<br />
CAUTION: Do not use fabric softener when washing the cleaning cloth or softener sheets when drying the<br />
cloth.<br />
Do not use liquid cleaners on the cloth as doing so will contaminate the cloth.<br />
Other lenses can also be cleaned safely with this Toraysee TM cloth.<br />
15.2 Cleaning the exterior of the projector<br />
How to clean the exterior of the projector ?<br />
1. Switch off the projector and unplug the power cord at the projector side.<br />
2. Clean the housing of the projector with a damp cloth. Stubborn stains may be removed with a cloth lightly dampened with a mild<br />
detergent solution.<br />
15.3 Level check of cooling liquid<br />
What should be done ?<br />
The projector is liquid cooled. When running with a low liquid cooling level then the cooling capacity is strongly reduced which results<br />
in higher temperatures inside the projector. These higher temperatures can cause an interruption of your show as the lamps can be<br />
switched off by the software as a preventive step.<br />
To avoid this problem, we strongly advise to check at least every 3 months the cooling level in the cooling reservoir of the projector.<br />
R59770057 <strong>CLM</strong> <strong>HD8</strong> 15/03/2010 167