CLM HD8 - Projector Central
CLM HD8 - Projector Central
CLM HD8 - Projector Central
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
16. Servicing<br />
CAUTION: Ensure that an unused slot is always covered with a dummy front plate. Immediately install after<br />
removing an input module a new input module or a dummy front cover.<br />
16.8 Inserting an input module<br />
Necessary tools<br />
Phillips screw driver PH1<br />
How to insert an input module<br />
1. Ensure the projector is switched off and the power cord at the projector side is unplugged.<br />
2. Slide the input module into the guides of the input slot.<br />
Image 16-12<br />
Insert module<br />
3. Push the input module forward until you feel that the connector of the input module fit in the socket of the input slot. The back of<br />
the front plate of the module must touch the front plate of the input unit.<br />
4. Secure the input module by fastening both captive screws in the top corners of the module.<br />
16.9 Top-up the reservoir with cooling liquid<br />
Access to the reservoir<br />
1. Switch off the projector and pull out the power cord from the power outlet.<br />
Remove :<br />
- lamp door, see "Removal of the lamp door", page 182.<br />
- front cover, see "Removal of the front cover", page 181.<br />
- back cover, see "Removal of the back cover", page 183.<br />
- top cover, see "Removal of the top cover", page 184.<br />
- side cover, see "Removal of the side cover", page 184.<br />
The reservoir is mounted half a way of the side of the projector.<br />
Top-up procedure<br />
1. Turn the bolt to release the pressure (1) . Turn until the white indication line is in the Open area (membrane is at the bottom of<br />
the reservoir) or until you feel to much resistance.<br />
2. If you feel to much resistance, turn off the main lid on top of the reservoir (A).<br />
R59770057 <strong>CLM</strong> <strong>HD8</strong> 15/03/2010 177