8550, 8550N, 8550DN, 8550GN, 8550MFP Printer

Message Description Recommended Action
RESTORING
FACTORY SETTINGS
SEPARATOR
OUTPUT BIN FULL
STACKER
OUTPUT BIN FULL
STAPLER LOW ON
STAPLES
STKR: ATTACH TO
PRINTER
STKR: CLOSE
STAPLER DOOR
STKR: DETACH AND
CLEAR JAM
STKR: TRAY
OVERLOAD
alternates with
CLEAR PAPER FROM
OPTIONAL BIN 1
The printer is resetting the
printer's factory defaults. The
printer is in the process of
completing a cold reset.
When the reset is completed,
the printer returns to the
ready state but remains
offline.
The multi-bin mailbox output
bins are full.
The multi-bin mailbox output
bins are full.
The Stapler Cartridge has 20
to 50 staples remaining.
The device is not attached to
the printer properly.
The Stapler door is open or it
is not closed properly.
A paper jam occurred in the
device.
The weight capacity of the
stacker bin has been reached.
Reset the EIO type and
configure the printer before
bringing the printer online. For
more information on factory
defaults and configuring the
printer control panel, see
chapter 2, “Using the Printer
Control Panel.”
Remove all media from the
output bins on the multi-bin
mailbox to continue printing.
Remove all media from the
output bins on the multi-bin
mailbox to continue printing.
No action required.
Make sure that there is a
proper attachment between
the device and the printer, and
wait for a solid green status
light on the user LED on the
device.
Close the Stapler door
properly.
Clear the paper jam.
Clear the paper from the
Stacker Bin.
154 7 Printer Control Panel Messages EN