CLIOwin 7 PCI User's Manual - Audiomatica
CLIOwin 7 PCI User's Manual - Audiomatica
CLIOwin 7 PCI User's Manual - Audiomatica
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Gating (Acquisition) Settings<br />
Gated Check Box<br />
Lets the user enable the gating acquisition mode. Checking it will automatically check<br />
Stepped Check Box. That is, Gated Measurements are always carried out in Stepped<br />
Mode.<br />
Delay Edit Box<br />
Lets the user define the delay, in ms, applied between the signal generation and its<br />
acquisition. When different than 0, gating is active, even when gating or Stepped<br />
check boxes (but not both) are not checked. Typical gated use is quasi anechoic<br />
Frequency Response Analysis where it removes the time delay of the sound leaving<br />
the Speaker and reaching the Microphone. Alternative use, with gated not checked,<br />
might be removing the delay between the play and recording head in a three heads<br />
tape recorder as well as any digital processor that introduces delay in the signal path.<br />
When the settings are Not Stepped and Not Gated the delay value is reset<br />
automatically to 0; CLIO introduces a large delay anyway between start of<br />
generation and acquisition. The highest Delay value accepted is 320ms.<br />
Auto Delay Check Box & Auto Delay Frequency Edit Box<br />
If Auto delay is checked, when delay is used (see above) CLIO tries, using the<br />
Frequency entered in the Edit Box, to determine the delay automatically. The value<br />
found is displayed in the Delay Edit Box; reopening the Settings Dialog after the<br />
measurements has been taken allows to you to view the automatically chosen delay<br />
time.<br />
Impedance Settings<br />
Set how Impedance is calculated. When taking impedance measurements refer<br />
either to the internal impedance mode or to the ISense feature of the CLIOQC<br />
Amplifier & SwitchBox Model 2,3 and 4. If QC Box Select is selected the hardware<br />
setting of the QC Box determines directly the Impedance Mode (please refer to chap.<br />
5.5.1)<br />
Distortion Settings<br />
An Edit Box allows you to type in the value, in dB, used by the graphical routines to<br />
raise the display of the distortion curves. Only the display of the curve is affected.<br />
The marker readings continue to display the real value which, if the rise value is<br />
different than 0, differs from the curve position.<br />
134 Chapter 11 - Sinusoidal