CLIOwin 7 PCI User's Manual - Audiomatica
CLIOwin 7 PCI User's Manual - Audiomatica
CLIOwin 7 PCI User's Manual - Audiomatica
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4.8.2 CONNECTING A MICROPHONE<br />
For acoustical measurements, the microphone (optionally followed by a preamplifier<br />
or power supply) requires to be connected to CLIO's input channel.<br />
When using a MIC-01 or MIC-02 microphone it is possible to connect it directly to CLIO's<br />
input; remember, in this case, to switch the phantom voltage on by pressing the<br />
phantom button . It is good practice to wait a few seconds before taking measurements<br />
as the microphone's output stabilizes.<br />
If the measuring point is far from the PC, always lengthen the connection between the<br />
preamplifier and CLIO. Make sure that you never use microphone cable that is longer<br />
than the one that has been supplied.<br />
In Fig. 4.27 we see the typical test setup for performing acoustical measurements of<br />
a loudspeaker. Please note that in this schematic diagram, which is drawn in the<br />
assumption of using one <strong>Audiomatica</strong> microphone MIC-01 or 02 directly connected to<br />
CLIO input; the output of the power amplifier is connected to the loudspeaker with an<br />
inversion in the cables polarity; this compensates the fact that MIC-01 and MIC-02<br />
microphones are phase inverting (as are the vast majority of measuring microphones<br />
found in the market); when making polarity measurements always treat the<br />
measuring chain in this respect considering that the CLIO hardware itself is NON-<br />
INVERTING and that all calibrations are usually made under this assumption: any<br />
external device like amplifiers, microphones, accelerometers, preamplifiers etc. has to<br />
be carefully checked.<br />
It is possible to achieve the same result, via software, simply clicking on the input<br />
polarity button in the hardware controls toolbar.<br />
CLIO<br />
INPUT (A OR B)<br />
OUTPUT (A OR B)<br />
MIC-01 OR MIC-02<br />
BLACK<br />
RED<br />
RED<br />
BLACK<br />
POWER AMPLIFIER<br />
Figure 4.27<br />
Chapter 4 - <strong>CLIOwin</strong> basics 53