CLIOwin 7 PCI User's Manual - Audiomatica

value of 6 ms, as long as the Frequency involved is high enough to allow this. Fig.11.6
is a plot of the Meter On Time Vs Frequency CLIO uses.
Figure 11.6
Users should use this graphic to determine the lowest Frequency that has been
measured in anechoic state. Using a fixed predefined Microphone and Loudspeaker
location makes all these parameters easier to define in routine measurement processes.
But for new situations it’s very advisable to run an MLS and have a look at the impulse
response obtained. Fig.11.7 shows the labels of the corresponding data to be input as
gating parameters.
Figure 11.7
Chapter 11 - Sinusoidal 139