Tutorials Manual

Chemkin 4.1.1
Chapter 3: Catalytic Processes
Figure 3-4
Catalytic Pre-combustor (C1_)—Honeycomb Monolith, Honeycomb sub-tab
Since there is no surface reaction in the homogeneous combustor and the post-flame
mixer, we need to turn the surface chemistry calculations off in our reactor models.
There are several methods to make the models ignore the surface chemistry. Here we
choose to set the surface reaction rate multiplier to 0.0, using the parameter at the
bottom of the Reactor Physical Property tab as shown in Figure 3-5.
Figure 3-5
Homogeneous Stage Combustor (C3_)—Reactor Physical Property
© 2007 Reaction Design 96 RD0411-C20-000-001