AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure for Sharp
Connect cables and wires
Connect all your AutoVu cables (for more information, see "Mobile installation examples
for Sharp" on page 78, and "Sharp wiring diagram" on page 82).
NOTE For more information on your vehicle’s internal wiring, see your owner’s manual.
The following conditions apply:
• Cables/wires for powering the tire cameras and Navigator unit are not included. 12V
DC power is required for both.
IMPORTANT Do not connect the Navigator unit or tire cameras directly to the vehicle’s
battery. These components should only receive power when your vehicle’s engine is
running.
• You’ll need to use your own wires to connect the Navigator unit to the vehicle’s ignition,
reverse signal, and odometry. Use stranded conductor copper wire for the ignition and
reverse signals, and shielded dual-stranded conductor cable for the odometry.
• Connectors are provided to connect your wires to the relays and inputs on the
Navigator unit. Use the connectors as shown below:
2-pole connector
(top view)
Use a 2.5 mm flat
head screwdriver (0.4
mm blade width) to
push here and open
the pole’s clamp
After inserting wire
into pole, push here
to close pole’s
clamp.
After connecting
to the Navigator
unit, make sure to
tighten the
securing screws.
Insert wire into open pole
here. Do not strip the
wire’s insulation. if you do,
the wire will be too small
for the clamp to secure it.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 90
EN.400.003-V5.1.C2(1)