AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure for Sharp
Install your Sharp camera
NOTE The mount’s magnets are extremely strong, and may be difficult to remove once
attached to your vehicle’s roof. If you need to adjust your Sharp’s position after it is attached,
you may find it easier to loosen the bolts rather than attempt to move the entire mount.
1 Locate the circular bracket underneath your Sharp camera, loosen the nut, slide the hex
bolt out, and remove the bracket.
Loosen nut and remove hex bolt to
detach circular bracket from Sharp.
2 Remove the four hex bolts from the mag-mount base, and then use them to attach the
circular bracket to the mag-mount.
3 Re-attach the Sharp camera to the circular bracket. Don’t tighten the bolts until after
you have properly positioned the camera.
Sharp with mag-mount.
4 Verify that the roof of your vehicle is clean, dry, and free of debris, and then place the
mag-mounted Sharp in the desired position on your roof.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 92
EN.400.003-V5.1.C2(1)