AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure
Mobile installation procedure
What you need
This section includes the following topics:
• "What you need" on page 95
• "AutoVu SharpX connections" on page 95
In addition to the AutoVu parts listed in the section "AutoVu hardware components" on
page 4, you will also require the following third-party components:
• 2.5 mm flat head screwdriver. Used for securing wires to the provided connectors.
• RJ45 crimp tool. Used to crimp the CAT5e cable wires.
• Three stranded copper wires. Used to provide power to the LPR Processing Unit. Two
wires should be 14 AWG, and the other should be between 20 AWG minimum to
14 AWG maximum.
• 15A in-line fuse. Protects the wiring to the vehicle battery.
• Weatherproof, non-corrosive sealant. For protecting cable connections.
About third-party connectors
This section describes the connectors that are included with the AutoVu SharpX system, but
are not manufactured by Genetec.
• Cable connectors are manufactured by Weidmuller. For more information, go to http://
www.weidmueller.com/56339/Home/cw_index.aspx and search for the following part
numbers:
• 1043920000 (3-pole)
• 1690910000 (5-pole)
• 1690880000 (2 -pole)
• The RJ45 connector is manufactured by Tyco Electronics. For more information, go to
http://www.tycoelectronics.com and search for part number 5-569552-3.
For a detailed T568B crimp procedure, click the “Application Specifications” link on the
part’s webpage.
AutoVu SharpX connections
This section includes a diagram that shows the supported SharpX connections. Each
connection is labelled A through G, and has specific steps you’ll need to follow. The
remaining topics in this section provide the required information on each connection. For
example, for more information on connection A in the diagram, see "Step A: Provide power
to the LPR Processing Unit (part 1)" on page 98.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 95
EN.400.003-V5.1.C2(1)