AutoVu Handbook 5.1 SR2 - Genetec

LED status on the SharpX camera unit
LED status on the SharpX camera unit
The following table describes how the SharpX camera unit’s LED behaves in response to the
SharpX system’s status.
State Description LED (red/green)
Off Unit is powered off Off
Reflash
Get DHCP
The unit has failed an integrity test on
the contents of the control board flash
memory. It waits for a reflash to be
performed over the network.
The unit is waiting for a DHCP lease
over the network (either from the LPR
Processing Unit or an external server,
depending on configuration).
Green (steady)
Blinks green rapidly (e.g. twice per
second).
Normal The camera is running normally. Flashes green briefly every second.
Covert
Thermal
Shutdown
Illuminator
Fault
Firmware
Fault
The camera is configured in covert
mode. It will still blink green a couple
of times at power-up.
The internal temperature is outside
the operational limits. Power is no
longer supplied to most components.
No Ethernet network connectivity is
possible.
An abnormal condition was detected
with the illumination. Depending on
the fault, the unit may run in degraded
mode (some LEDs shut off), or the
illuminator may be completely
disabled.
A critical fault was detected in the
control board microcontroller.
Off
Toggles slowly every second.
Blinks red rapidly (e.g. twice per
second).
Red (steady)
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 245
EN.400.003-V5.1.C2(1)