AutoVu Handbook 5.1 SR2 - Genetec

Phase 7: Configure Patroller
Phase 7: Configure Patroller
This is what you need to do in Patroller Config Tool to configure Patroller for Law
Enforcement. You’ll learn how to add Sharp cameras to the in-vehicle LAN, connect
Patroller to Security Center, configure offload options, and more.
Before you begin: Read about Patroller Config Tool and take a tour of the user interface.
This section also shows you how to log on and off Patroller Config Tool. For more information,
see "Patroller Config Tool interface tour" on page 13.
This section includes the following topics:
• "Add the Sharp cameras to Patroller" on page 58
• "Connect Patroller to Security Center" on page 58
• "Configure offload options" on page 59
• "Configure the Patroller unit name and logon options" on page 59
• "Configure Patroller hit options" on page 60
• "Configure the Patroller navigation and map settings" on page 60
• "Customize the Patroller user interface" on page 61
Add the Sharp cameras to Patroller
After you have physically connected the Sharp hardware, you need to add the Sharps to the
in-vehicle LAN. Patroller can auto-detect connected Sharp cameras and add them for you.
You’ll then need to select the camera’s orientation.
For more information, see "Connecting Sharp units to Patroller" on page 137.
Related topics:
• Go back to AutoVu mobile deployment overview.
• Go to top of Phase 7: Configure Patroller.
Connect Patroller to Security Center
Even if you are not monitoring LPR events in Security Desk, you’ll still need to perform this
procedure at least once in order for Security Center to detect the Patroller unit.
For more information, see "Connect Patroller to Security Center" on page 48.
Related topics:
• Go back to AutoVu mobile deployment overview.
• Go to top of Phase 7: Configure Patroller.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 58
EN.400.003-V5.1.C2(1)