AutoVu Handbook 5.1 SR2 - Genetec

Hardware specifications and system requirements
Hardware specifications and system requirements
For more information about AutoVu hardware, including detailed specifications such as
camera lens options, operating/storage temperatures, and more, click the links below to
download the Sharp and SharpX specification sheets:
• Download the AutoVu Sharp spec sheet.
• Download the AutoVu SharpX spec sheet.
About the hardware installation procedures in this guide
Safety precautions
The hardware installation procedures in this guide are based on typical AutoVu hardware
installations. AutoVu’s versatility allows you to customize an installation in a number of
ways, and you may need to deviate slightly from the installation procedures depending on
your individual setup (e.g. your installation site or type of vehicle). For questions about
your specific installation, contact your Genetec representative.
The following section describes the safety precautions regarding AutoVu installations. Read
this section before beginning your fixed or mobile AutoVu installation.
WARNING Neglecting to observe the following safety precautions could result in physical
harm, and/or severe damage to your hardware.
• It is extremely dangerous to allow the cables to become wound around the steering
column or shift lever. Be sure to install this product, its cables, and wiring in such a
way that they will not obstruct or hinder driving.
• Do not install this product or route any wires in the deployment area of your air bag.
Equipment mounted or located in the air bag deployment area will damage or
reduce the effectiveness of the air bag, or become a projectile that could cause serious
personal injury or death. Refer to your vehicle’s owner manual for the air bag
deployment area. The User/Installer assumes full responsibility for determining
proper mounting location, based on providing ultimate safety to all passengers
inside the vehicle.
• Do not route wires where they will be exposed to high temperatures. If the insulation
heats up, wires may become damaged, resulting in a short circuit or malfunction
and permanent damage to the product.
• Only personnel who have special training and experience in automobile electronics,
should set up and install this product. Installing or servicing this product and its
connecting cables may expose you to the risk of electric shock or other hazards, and
can cause damage to the system that is not covered by warranty.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 63
EN.400.003-V5.1.C2(1)