AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation guidelines
Mobile installation guidelines
Best practice: Observe the following best practices and general warnings when you are
choosing where to install the Sharp camera(s).
• Use dielectric gel on the SharpX camera connector.
• Don’t bring the SharpX through a mechanical car wash.
• The SharpX camera is IP67 compliant only when the plastic protector cap is on, or
when the cable is secured to the camera as described in "Step E: Connect the SharpX
cable to the SharpX camera" on page 102.
• You can install the LPR Processing Unit on its side, but make sure the heat sink’s fins
are exposed to as much air as possible (contact your Genetec representative for available
mounting brackets).
• You will void the warranty if you open or drill holes in AutoVu equipment, or if you
paint, or add decals to a SharpX camera.
• For the procedures in Step A: Provide power to the LPR Processing Unit (part 1) and in
Step D: Connect the SharpX power cable to the LPR Processing Unit, insert the wires
into the poles so that there's no exposed bare wire, but not too deep so that the tension
clamp closes over the insulation rather than the wire itself.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 94
EN.400.003-V5.1.C2(1)