AutoVu Handbook 5.1 SR2 - Genetec

Using a SharpX system with multiple LPR Processing Units
Using a SharpX system with multiple LPR Processing Units
If you are using two SharpX LPR Processing Units on the same network (e.g. in the same
vehicle), follow the procedures described in this section to resolve the IP address conflicts
between the units.
This section includes the following topics:
• "About the LPR Processing Unit’s default IP addresses" on page 144
• "Change the LPR Processing Unit’s default IP addresses" on page 145
About the LPR Processing Unit’s default IP addresses
All SharpX LPR Processing Units have seven internal components. Each component has a
factory-assigned static IP address. These components are:
Component
Default IP address
Single Board Computer 1 (SBC1) 192.168.10.1
Single Board Computer 2 (SBC2) 192.168.10.2
Genetec Video Processor 1 (GVP1) 192.168.10.3
Genetec Video Processor 2 (GVP2) 192.168.10.4
Camera Unit 1 (CAMU1) 192.168.10.5
Camera Unit 2 (CAMU2) 192.168.10.6
Mobile Processing Unit (MPU) 192.168.10.7
Camera Unit 3 (CAMU3) a
192.168.10.8
Camera Unit 4 (CAMU4) 1 192.168.10.9
a. For SharpX – Multi with four camera ports.
If you're using only one LPR Processing Unit on the network (e.g. in a vehicle), you don't
have to change any of the default settings, but if you're using two units on the same network
(sometimes referred to as “daisy-chaining”), the duplicate IP addresses on the units will
conflict. This means you'll need to change the default IP addresses on one of the units. You
can do this using the Sharp Admin.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 144
EN.400.003-V5.1.C2(1)