AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure
2 Strip 10 mm (3/8”) of insulation from the wires you exposed in "Step C: Connect the
SharpX CAT5e cable to the LPR Processing Unit" on page 99 (drain wire has no insulation),
push in the tension clamps with your screwdriver, insert the wires, then release
the clamps. Gently tug the wires to make sure they are secure.
Insert screwdriver and push
to open the pole’s tension
clamp. Remove screwdriver
to close clamp.
While clamp is open,
insert wire here.
Drain wire.
Tinned copper.
Red wire.
Grey wire. (see Note)
Yellow wire. (see Note)
NOTE Maintain twisting of the grey and yellow wires until 10 mm (3/8”) from the
connector.
3 Repeat these steps for your other SharpX camera(s) as needed.
Step E: Connect the SharpX cable to the SharpX camera
This section shows you how to connect the SharpX cable to the SharpX camera.
Return to diagram, click here.
CAUTION Secure and tighten the cable connector to the SharpX camera, otherwise water
may leak into the camera.
IMPORTANT
Black wire.
• Do not tighten the cable by turning the cable cord.
• Do not turn the cable from behind the outer ring.
• Do not use any tools to tighten the cable.
1 Remove the plastic protector cap from the camera.
2 Put dielectric gel on the cable connector threads.
3 Align the notch on the cable connector with the notch on the camera port.
4 Attach the cable to the SharpX camera.
5 Align the connector threads and tighten the connector by turning the outer connector
ring clockwise.
6 Tighten the connector as much as possible by hand. Don’t use a wrench or other tool to
tighten it.
Step F: Connect the LPR Processing Unit to the computer
Connect the LPR Processing Unit to the in-vehicle computer using the provided Ethernet
cable.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 102
EN.400.003-V5.1.C2(1)