AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure for Sharp
• Connect your wires as follows:
Navigator connection
Relays 1 and 2
Inputs 1A and 2A
GND
Inputs 1D and 2D
IGN
GND
REV
What it’s used for
90V relays used for switching auxiliary equipment.
Analog inputs used to measure battery voltage, temperature, etc.
Grounding
Digital inputs used for sensors handling events such as doors
opening, etc.
Ignition input. State of the vehicle’s power system.
Grounding
Reverse input. Connect to vehicle’s reverse signal (required for
inertial navigation).
- ODO and + ODO Odometry inputs. Connect to the vehicle’s odometry signal (required
for inertial navigation).
Finishing up
1 Start your vehicle to verify that your AutoVu hardware, as well as your vehicle’s other
electrical devices, are working properly.
2 Seal the holes in the vehicle’s roof with a weatherproof sealant, such as RTV silicone.
3 Replace the vehicle’s headliner and any other parts you removed to install your AutoVu
hardware.
Magnetic mount installation
Your AutoVu hardware can be used as a portable LPR solution with a single Sharp camera
on a magnetic mount (mag-mount), connected to a breakout box that is plugged into your
vehicle’s cigarette lighter.
This section includes the following topics:
• "Install your Sharp camera" on page 92
• "Connect cables and wires" on page 93
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 91
EN.400.003-V5.1.C2(1)