AutoVu Handbook 5.1 SR2 - Genetec

Connecting Sharp units to Patroller
b
c
Click Start discovery.
Patroller detects the connected Sharps and adds them to the Units list.
Make sure each Sharp in the Units list has a different orientation. To do this, click on
a Sharp, click the Edit button ( ), and then change the orientation of the Sharp to
match where the Sharp is located on the vehicle.
When selecting the orientation, if there are two LPR cameras shown for one Sharp
unit, it means that the Sharp is connected to an LPR Processing Unit with multithreading
capability, and a single “Unit” is actually controlling two Sharp cameras.
In this case, make sure that both LPR cameras have a different orientation.
If you see two LPR
cameras, it means
you’re on a SharpX -
Multi system.
Spell the camera
names exactly as
shown. They must be
“Lpr Camera” and
“Lpr Camera 2”
(case-sensitive).
4 (Optional) If you want to manually add a Sharp camera instead of using the automatic
discovery feature, click the Create button ( ), and do the following:
a Under Unit, enter the Sharp’s IP address (e.g. 192.168.10.1), or the Sharp name as it
appears on the Sharp camera unit’s label (e.g. Sharp1234).
If you’re using a SharpX - Multi system, the “unit” corresponds to a single processor
on the LPR Processing Unit, which controls two SharpX cameras. In this case, go to
Step b to add your second camera. If you don’t have a SharpX - Multi, go directly to
Step c.
b (For SharpX - Multi) Under Cameras, click the Create button ( ) to add the second
LPR camera.
IMPORTANT Please note the following:
c
Enter camera names as “Lpr Camera” and “Lpr Camera 2” (case-sensitive).
You can’t add more than two LPR cameras. If you do, you will receive an error
when you click Apply.
Choose the camera’s orientation from the drop-down list.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 138
EN.400.003-V5.1.C2(1)