AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure
2 Strip 10 mm (3/8”) of insulation from the stranded copper wires, push in the tension
clamps with your screwdriver, insert the wires, then release the clamps. Gently tug the
wires to make sure they are secure.
Permanent 12V (+).
Use 14 AWG wire.
Negative/Return/Ground
(GND)
12V ignition (IGN).
Use 20 AWG wire
minimum to 14 AWG
wire maximum.
Apply pressure with
screwdriver here to
open pole’s tension
clamp. Release
pressure to close
While clamp is open,
insert wire here.
Best practice: Use a red wire for power (+), black wire for ground (GND), and yellow wire
for ignition (IGN) to be consistent with similar Genetec installations.
Step B: Provide power to the LPR Processing Unit (part 2)
This section shows you how to connect the SharpX power cable to the vehicle.
Return to diagram, click here.
Before you begin: You’ll need a 15A in-line fuse ready.
IMPORTANT These instructions are not intended to replace the vehicle’s owner manual. If
you are unsure about the vehicle’s internal wiring, refer to the owner manual before
continuing.
1 Connect the wire from the LPR Processing Unit’s + pole, through the 15A in-line fuse,
to the vehicle’s 12V power source (permanent +12V).
NOTE Install the fuse at the source of the vehicle’s 12V system tapping point. The LPR
Processing Unit is already protected internally by an electronic circuit breaker.
2 Connect the wire from the LPR Processing Unit’s GND pole to the vehicle’s chassis for
grounding.
3 Connect the wire from the LPR Processing Unit’s IGN pole to the vehicle’s ignition signal
(+12V active when at ON/RUN key position).
Step C: Connect the SharpX CAT5e cable to the LPR Processing Unit
This section shows you how to connect the SharpX CAT5e cable to the LPR Processing Unit.
The SharpX camera cable is an “all-in-one” cable that contains the shielded CAT5e
conductor wires you need to crimp and connect to the included RJ45 plug (also shielded).
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 99
EN.400.003-V5.1.C2(1)