AutoVu Handbook 5.1 SR2 - Genetec

Fixed installation procedure
Fixed installation procedure
What you need
This section describes a typical installation procedure for a Sharp XGA. It also includes
guidelines for the Sharp EX.
This section includes the following topics:
Install your Sharp XGA
• "What you need" on page 73
• "Install your Sharp XGA" on page 73
• "Install your Sharp EX" on page 75
In addition to the AutoVu parts listed in the section "AutoVu hardware components" on
page 4, you may also require the following third-party components:
• Surge protector. For ethernet (GigE required) and power.
• Electrical enclosure. Must conform to NEMA standards.
• Flexible liquid-tight conduit. For protecting the Sharp camera cable.
• Weatherproof, non-corrosive sealant. For protecting cable connections.
WARNING Before you begin your installation, make sure that power to the installation site
is not active. Power should only be activated when the installation is complete.
This section includes the following topics:
• "Step 1: Mount the Sharp" on page 73
• "Step 2: Connect the Sharp" on page 74
• "Step 3: Mount the electrical enclosure" on page 74
• "Step 4: Finishing up" on page 75
Step 1: Mount the Sharp
1 Attach the camera mount to the wall, pole, or other base that will support the Sharp
camera. Refer to the camera mount’s documentation for more information.
2 Locate the circular bracket underneath the Sharp, loosen the nut, slide the hex bolt out,
and remove the bracket.
Loosen nut and remove hex bolt to detach
circular bracket from Sharp.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 73
EN.400.003-V5.1.C2(1)