AutoVu Handbook 5.1 SR2 - Genetec

Mobile installation procedure
2 Crimp the wires according to the TIA/EIA-568-B.1-2001 specification, using the T568B
conductor arrangement. Remember that the cable and connector are shielded, so you
need to fold the foil shield so it has contact with the RJ45’s metal shell.
3 After you’ve attached the RJ45 connector, plug the CAT5e cable into the into the first
Data Link port.
Connect RJ45 here
4 Repeat these steps for the other SharpX camera as needed.
Step D: Connect the SharpX power cable to the LPR Processing Unit
This section shows you how to connect the SharpX power cable to the LPR Processing Unit.
NOTE SharpX connectors use push-in tension clamps to secure the wires.
Return to diagram, click here.
Before you begin: You’ll need a 2.5 mm flat head screwdriver.
1 Attach the 5-pole connector to the camera port, then tighten the securing screws.
Make sure to tighten the
securing screws.
genetec.com | AutoVu Handbook 5.1 SR2 | Download latest version 101
EN.400.003-V5.1.C2(1)