equipment sourcebook - Loctite.ph

LIGHT CURE
Cure Chambers & Flood Systems
Cure Chambers &
Flood Systems
Loctite® brand chamber and flood systems are modular low and medium intensity
ultraviolet and high intensity visible light emitting units designed for the batch curing
of light curing adhesives and coatings. Selection of a Loctite® brand chamber and flood
system is based on the required intensity of light and cure area.
CURE CHAMBERS
LOCTITE ® UVALOC 1000 UV CURE CHAMBER
Item Number: 805741
The Loctite® UVALOC 1000 UV Cure Chamber, item 805741, is a highperformance
modular curing system consisting of a cure chamber,
lamp housing, and controller. The chamber has four rack levels to
accommodate a slide-in tray that allows for easy positioning of parts of
various heights and level of optimum exposure. The lamp is shielded by
a timed control shutter that eliminates UV exposure to operators during
loading or unloading of parts. A door safety switch prevents opening
while exposure is in progress.
Features:
• Typical UV irradiance is up to 110 mW/cm 2 , depending
upon selection of 4-position rack height
• Dual power setting of 500 or 1000 watts permits curing
of temperature-sensitive parts without damage by heat
• Lamp intensity is continually monitored
• Low-level output condition can be established to insure optimal
curing performance and notification for lamp replacement
• Effective cure area of 6.3 inches wide by 6.3 inches deep (160 mm x 160 mm).
• Digital timer allows for setting exposure time from 3 seconds to
15 minutes in one-second increments
• Pneumatically-operated shutter prevents
TECHNICAL SPECIFICATIONS
UV exposure to operators
Input Voltage
240 VAC; 50/60 Hz
• Safety door interlock switch prevents
opening of the door while the shutter is open
• Standard lamp included is mercury vapor lamp;
365 nm wavelength
Pneumatic Supply Required
Pneumatic Supply Tubing
Power Consumption
60 to 90 psi
6 mm
1,200 watts
• Optional iron doped or
gallium doped lamps available
Dimensions Exterior of Unit
Cure Chamber
12.0" W x 29 1 ⁄4" H x 17.0" D
9.0" W x 12" H x 13 3 ⁄4" D
Cure Area
6.3" W x 6.3" D
Theory of Operation
The operator places the part inside the chamber
and sets the exposure time. This cure time is
controlled by the built-in timer and can be
operated in a continuous or timed mode. The
operator then triggers the exposure cycle by a foot
switch, panel-mount start button, or PLC interface.
Upon completion of timer, the operator removes
the part from the chamber.
NEW
Parts
Included
Replacement Bulb
(1) Cure Chamber, Lamp Housing, and Controller
(1) UV Intensity Sensor and Built-In
Digital Intensity Display
(1) Connecting Cable (from controller to lamp housing)
(1) AC Power Cord with pig-tale wire ends
(1) Foot Switch
870098 – 1,000 W Mercury Vapor
Additional Accessories Sold Separately
98086 – Loctite ®
ZETA ® 7011-A
Dosimeter-Radiometer
(See page 113)
98452 – Safety Glasses
(protects from 200 to
540 nm wavelengths)
870097 – Iron Doped Lamp 870096 – Gallium Doped Lamp
108
For additional information and the full line of equipment, visit www.equipment.loctite.com.