OPERATOR'S MANUAL - The Baker Company Blog

366D000M 1/4/2011Method to seal an SG cabinet for decontaminationImportant: After reviewing this procedure, clean areas being taped to assure a good seal.1. Loosen and remove cap nuts holding downthe exhaust filter protective screen locatedon top of the cabinet and then remove thescreen. (See Figure 3)CAUTION: Use care when removingscreen to avoid damaging the exhaust filter.Figure 32. Clean cabinet surfaces where tape is goingto be applied with alcohol and watersolution for better tape adhesion.Tape 127mm to 152.4mm (5 to 6”) thickspacers to the center front of the lightcanopy and above the sash handles toprovide an air passage from the top exhaustfilter opening to the front access opening.Leave the sash at its normal operatingheight. (See Figure 4)Install decontamination equipment in thecabinet work area.Figure 428