OPERATOR'S MANUAL - The Baker Company Blog

366D000M 1/4/20113. With sheet plastic 4-mil thick or thicker, cuta piece large enough to tape over the topextending down the front to the bottom ofthe drain pan and around to the side panels.(See Figure 5)Figure 54. Center the plastic sheeting over the cabinetfrom right to left.Using 76.2mm (3”) wide good qualityplastic tape, start taping the sheeting at thetop rear of the cabinet over all cablebrackets. This area provides a flat surfacethe length of the top panel for taping. Avoidwrinkling the sheeting. (See Figures 6 and7)Figure 6Figure 75. Continue to tape the sheeting around theback corner down the sides. If present, tapeover cable ports or plug with cable port plugprovided.Fold and overlap plastic as required to get atight fit on the sides. Tape folds in place.(See Figures 8-11)Cable Port PlugFigure 8Figure 9Cable PortFigure 10Figure 1129