Leica TPS400 Series User Manual

Enter offset values!Trav. Offset: 0.600 mLength Offset: 0.800 mHeight Offset: 0.500 mMode : Reset after RECRESET CYLNDER OKProcedure:1. Enter the offset values (length, cross and/orheight) as per the sketch.2. Define the period for which the offset is to beapplied.[RESET]: Sets eccentricity to zero.3. [SET]: calculates the corrected values andjumps to the application from which the offsetfunction was started. The corrected angle anddistances are displayed as soon as a validdistance measurement has been triggered orexists.The period of applicability can be set as follows:Reset after RECPermanentThe offset values are reset to 0after the point is saved.The offset values are applied to allfurther measurements.The offset values are always reset to 0 whenthe application is quit.Cylinder Offset subapplicationUse [CYLNDER] to determine the coordinates of thecentre point of cylindrical objects and their radius.Measure the horizontal angle to a point on the leftand on the right side of the object as well as thedistance to the object.FNC Key45TPS400-5.0.1en