Leica TPS400 Series User Manual

ConstructionThis application allows to define a construction siteby combining set-up of the instrument along aconstruction line, measuring and setting out pointsin relation to the line.After selecting the application you have twooptions:a) Defining a new construction siteorb) Continue with previous site (skips set-up)Procedure:Defining new site:1. Measure line Start point [ALL], [DIST]+[REC]2. Measure second line point [ALL], [DIST]+[REC]In case, you have entered coordinates byENHand measured to known points a plausibilitycheck informs you about the calculated line length,the actual length and the difference.As built check:This dialog shows you the Line, Offset andHeight of a measured point in relation to the line.PtID :A11hr : 1.500 m: 7.225 mOff: 10.194 m: -1.673 m[ShiftLn]Allows you to enter values forshifting the line.[LAYOUT] Switches to Layout-mode.Line is positive:Measured point is in direction from line start - to lineend point.Offset is positive:Measured point is right of line.Height is positive:TPS400-5.0.1en80 Programs