Leica TPS400 Series User Manual

Measured point height is above line start point’sheight.The height of the line start point is alwaysusedas the reference height!LayoutHere you can search or enter points for staking outrelated to the measured line.[ShiftLn][AsBUILT]Allows you to enter values forshifting the line.Switches to AsBuilt-mode.The graphics show you the position of the prismrelated to the stake out point. Below, the exactvalues are displayed, combined with arrows to showthe direction.Line is positive (arrow up):Target point is further away than the measuredpoint.Offset is positive (arrow right):Target point is right of the measured point.Height is positive (arrow up):Target point is higher than the measured point.The height of the line start point is alwaysusedas the reference height!The graphics are scaled to give a betteroverview.Therefore it’s possible that the stationpoint moves in the graphics.Be aware that the line start point and the lineendpoint are measured in the previous coordinatesystem. When staking out this points they appear inthe old system and appear as shifted.Programs81TPS400-5.0.1en