Thermo Scientific Orion 2110XP Ammonia Analyzer

Analyzer PreparationElectrical WiringThe warning icon highlights important information that should be strictlyfollowed when using the analyzer for your own safety. Failure to followthese instructions may result in injuries.Warning: Read and observe the following safety recommendations.Safety Requirements• Prior to wiring, a switch or circuit breaker for disconnecting theanalyzer from power supply should be installed.• The switch should be in close proximity to the analyzer and witheasy reach of the user.• The switch should be marked as the disconnecting device forthe analyzer.• To reduce the risk of shock hazard, disconnect the power prior toopening the analyzer.• Before connecting the analyzer to the main, make sure that the voltagelies within either range: 85 to 132 V, 200 mA or 170 to 264 V,100 mA; 50 to 60 Hz AC.• Cutting off the power by disconnecting power source will not reset theanalyzer. This analyzer incorporates a non-volatile memory and willmaintain calibration and settings after power failure. Battery power issupplied to the display for the date and time functions.• If a repair is required, or to arrange Return Material Authorization, callTechnical Support or contact your local authorized dealer.• Installation and wiring of the analyzer may only be carried out inaccordance with applicable local and national codes per this user guide.• Be sure to observe the technical specifications and input ratings.Thermo Scientific Orion 2110XP Ammonia Analyzer User GuideII-4