Thermo Scientific Orion 2110XP Ammonia Analyzer

Analyzer OperationUse of theSetup ModeBefore the first sample measurements can be taken, the setup mode shouldbe programmed and a successful calibration must be performed by theoperator and stored in the memory of the analyzer.Navigating Tips for theSetup Mode• Press to enter the setup mode.• SETUP appears in the mode indicator screen.• HOLD is displayed while in the setup mode.• The analyzer will enter the setup mode at the last menu that was usedby the operator.• Press and to loop through the menu options.• Press to select the desired menu option and set the menuoption parameters.• Press and to:• Scroll between On and OFF for the selected menu option.• Scroll and set the first digit value to 0 through 19.• Scroll and set the remaining digit values to 0 through 9.• Press to move to the next digit (scroll right) to set each digit value(4 digits maximum).• Press to save the entered parameter for the selected menu option.• Press to exit the current screen and return to the previous screen.• Press to exit the setup mode and return to the measure mode. Ifis pressed, will not return the operator to the setup mode.The operator must reenter the setup mode by pressing .Channel Specific MenuOptions in the Setup ModeIf a single channel analyzer is in use, all of the menu options are accessibleby pressing / in the setup mode. The system will loop throughthe menu options and all of the menu options are in the same level of thesetup mode.If a two channel analyzer is in use, only the general menu options areaccessible by pressing / in the setup mode. The channel 1 andchannel 2 specific menu options must be accessed by selecting the CH1 orCH2 menu options in the setup mode. The channel specific menu optionsare in the second level in setup mode. If a two channel analyzer is in use,make sure to program both the channel 1 and channel 2 menu options inthe setup mode.Thermo Scientific Orion 2110XP Ammonia Analyzer User GuideIII-3