Inclination sensors

Frequency, currentand voltage convertersCurrentControl ModuleFor special current-regulated or current-controlled actuators the output currentis measured and read via the analogue inputs of the controller R360.The CurrentControl module detects the measured current and provides it asan input signal. These modules are mainly for the control of hydraulicmotors. As the control currents of these aggregates are usually very low themeasured current is limited to max. 200 mA. The control function is implementedin the application program.GeneralinformationList of articlesPWM OUT14load (+)Block diagramof theCurrentControlModule.MobilecontrollersDialoguemodulesTechnicalinformationand customerserviceConnectiontechnologyI/O-modulesanalogue IN2GND3Diagnosisand serviceSensorsfor mobileapplicationsSignalconvertersAccessories5load (-)If the ratiometric inputs of the R360 cannot be used and a constant supplyvoltage, e.g. for joysticks or potentiometers, is needed, the DC/DC convertercan be used. Independent of the input supply (within the permissible operatingvoltage range) the DC/DC converter generates a constant output voltage.At the same time there is an electrical separation.DC/DC converterwith electricalseparation.18-36 V DC 10 V DCVisit our website: www.ifm.com123