Inclination sensors

I/O moduleswith CANopen interfaceCabinetModules – flexibility for operating panels and cockpitCabinetModules are especially suited for processing signals in operatingpanels and in the cockpit. The flat design enables easy integration in dashboardsand operating panels. These devices are also used in smaller machineswith decentralised control cabinets.To connect the switches, sensors and actuators the important potentials aremade available to the device connectors. This eliminates the need of furtherterminals. The parameter setting of the inputs and outputs provides the rightfunction for every application. Configuration is done from the user programvia the object directory. For four input channels the user can select the functionanalogue or digital input. For these devices the ratiometric measurementis also supported. This means that for example analogue joysticks canbe directly evaluated just by reading back the supply voltage without additionalreference voltage. Supply voltage fluctuations then have no influenceon the measured value.CabinetModules are an easy option to give analogue joysticks CANbuscapability.Space-savingI/O modules formounting in thecockpit and operatingpanels.GeneralinformationList of articlesMobilecontrollersI/O-modulesKeypadModule – the I/O module for the operatorIn operating panels a large number of keys and signal indicators are oftenneeded. Conventional keys and indicators require much installation spaceand complex mounting.The KeypadModule has a great advantage, in particular with respect tothese two points. Irrespective of whether the device is surface or panelmounted – with few mounting steps and easy wiring on the CAN bus it isquickly ready for use.LED row 1and arrow keystop left / rightLED row 2and arrow keysbottom left / rightMany functionsof the Keypad-Module canbe freely definedthrough parametersetting.AccessoriesDialoguemodulesDiagnosisand serviceSensorsfor mobileapplicationsSignalconvertersConnectiontechnologyEach of the 12 function and 4 arrow keys enables the following operatingmodes:In the mode “pulse operation” each key is active as long as it is pressed. Ifneeded, a timer on delay is also possible.In addition, the keys also support the operating mode “latching”. Theyremain active until they are pressed again.Via the IEC function “CR1500” of the CoDeSys programming software thekey status is transferred to the application.The status LEDs can be triggered individually. Depending on the operatingstate they are off, permanently on or flash at 2 freely selectable frequencies.The LED rows are another display option. The individual segments can betriggered in red or green. Additionally, the operating mode “segment row”with or without colour change is possible.Technicalinformationand customerserviceVisit our website: www.ifm.com57