OpenEdge Management and OpenEdge Explorer: Configuration

NameServer logging level
(dynamic property)
Configuring a NameServer
Table 4–1: NameServer properties (3 of 6)
Property category or property Description
A value that specifies the amount of
information that is written to the NameServer
log. Select from the following values in the
drop-down list:
• None — Log no entries. This is
equivalent to turning logging off.
• Error Only — Log OpenEdge error
messages. This includes all error
messages and is unrelated to the entry
types specified. Errors continue to be
logged at all higher levels.
• Basic — Logging entry types determine
the logged information. Each entry type
generates at least some output. This is
the default.
• Verbose — Logging entry types
determine the logged information, but it
is typically more information than Basic.
• Extended — Logging entry types
determine the logged information, but it
is typically more information than
Verbose.
The installed default is Basic.
You can update this property dynamically.
Any changes will affect all current and new
NameServers.
Append to NameServer log file A check box that indicates whether a new
server log file should be created when the
NameServer is started.
To create a new NameServer log file each
time the NameServer is started, even if the
NameServer log file already exists, clear the
check box.
To append log entries to the existing
NameServer log file, select the check box.
Append to NameServer log file is selected
by default.
4–7