OpenEdge Management and OpenEdge Explorer: Configuration

Configuring AppServers and AppServer Internet Adapters
5–36
Table 5–16: AIA Controlling NameServer properties (2 of 2)
Minimum NameServer client port
and
Property Description
Maximum NameServer client port
These properties are used to limit the range of
ports of an AIA communicating with the
NameServer via UPD. This is important when
the AIA and NameServer are separated by a
firewall.
The value for these two properties must be a
number between 1024 and 65535 inclusive (or
0), and Minimum NameServer client port
must be less than or equal to Maximum
NameServer client port.
If the minimum and maximum values are both
set to zero, then a random port number within
the implicit fixed range will be dynamically
assigned.
If both minimum and maximum values are set
to the same port number, then this UDP port
number will be used when communicating
with the NameServer.
The default value for both minimum and
maximum is 0.
AppServer host name If you did not select the Connect using
NameServer check box and the AIA will be
directly connected to an AppServer or
SonicMQ Adapter, you must specify the
AppServer's or SonicMQ Adapter's host
location.
AppServer port If you did not select the Connect using
NameServer check box and the AIA will be
directly connected to an AppServer or
SonicMQ Adapter, you must specify the
AppServer's or SonicMQ Adapter's port.