MPX Series Video Encoders Front Panel - Teleste

Mgmt connectionMgmt connector (RJ-45 female).PinCCIN+ IN-CC inputor+ -TTLlevel voltageSignal1 Ground2 Mgmt out3 Ground456 Mgmt in78Mgmt connector’s pinout. Arecommended management cable isTeleste CIC504.CCIN+ IN-ShortcircuitContact closure connections.CC outputCCOUTRelay on/off(24V / 1A)The Mgmt (Management) connector provides one bi-directional(RS232) data channel. The Mgmt connection is for local confi gurationand control of MPX series encoders. The command line interface (CLI)is intended for administration use, and can be accessed locally usingserial terminal program or remotely using telnet program. Typical use ofthe CLI is to set up the IP address for the encoder, update the encoder’ssoftware and for remote diagnostics.PC/PSION D9 female RJ-45 male MPX encoderReceive data 2 2 Mgmt outputTransmit data 3 6 Mgmt inputSystem ground 5 1 GroundManagement cable (CIC504) pinout (D9 female / RJ-45 male).Contact closure loop (CCL) connection (optional)The MPC series video encoders provides optionally 1 or 3 bi-directionalcontact closure channel lines. The MPX series video encoders providesoptionally 4 or 8 bi-directional contact closure channel lines.There are optionally two different CC input connection ways, one for anormal short circuit (dry contact closure) on / off - input signals betweenconnector’s contact pins (internal power source) and one for TTL levelvoltage input signals (data rate max 5 Hz, sink current 20 mA at 5V DC)between contact pins (external power source). CC output is a normalrelay on/off - output signal (24V / 1A) between connector’s contact pins.Depending on the model, the CCL connector type is a 4 or 8 - pinscrew terminal.MPX series video encoders user manual 11