MPX Series Video Encoders Front Panel - Teleste

ConnectionsGeneralAll products in the MPX family have the same connection scheme intheir connectors. Depending on the model, there are Video, Data,Audio, Contact closure, Mgmt & Ethernet connections.Video connectionsNote! Alternatively the video inputimpedance can be set to high mode(MPC-EZ and MPC-E1 HW versionG onwards).The video connector type is a BNC female. The video input impedanceis 75 Ω. The nominal input level is 1 Vpp. Video inputs are wequippedwith dual colour VIDEO indicator led’s on the front panel. Video portsettings can be confi gured from web user interface (WebUI).Led Colour Video modeVideoGreenYellowDarkPort confi gured and video OKPort confi gured and no videoPort not confi guredVideo indicator led operation.Data connectionsAll data connectors provide one bi-directional data channel. Data portsettings can be confi gured from web user interface (WebUI). Supporteddata types are RS232, RS422, RS485-2w and RS485-4w.A recommended cable for data connection is Teleste CIC603.MPC dataconnectors (2 xRJ-45 female).MPX dataconnectors (3 xRJ-45 female).PinColour1 White / green stripe2 Green3 White / orange stripe4 Blue5 White / blue stripe6 Orange7 White / brown stripe8 BrownCIC603 cable’s pinout / wire colors(RJ-45 male / open wires).Pin RS232 RS422 RS485-2w RS485-4w1 out + in / out + out +2 out out - in / out - out -3 in - in / out - in -45 Ground Ground Ground Ground6 in in + in / out + in +78 Ground Ground Ground GroundData connector’s pinout and supported data types.RS232 is an unbalanced data format (i.e. the signal wire workingagainst a reference – ground). Simplex RS232 requires two connections(signal and ground). Full-duplex RS232 requires three connections(signal TX, signal RX and ground).MPX series video encoders user manual 7