MPX Series Video Encoders Front Panel - Teleste

Changing Contact closure output state by motion detection sensorIn this case encoder changes CC output state (open/close) when motion isdetected by MD1 (motion detection 1) sensor. In this example you arecontrolling CC (contact closure) output which does not affect video stream.Select “0: Pass all frames” or “1: Pass I-frames” option1. Click “Connection” menu under the Configuration/Video/Edit VideoEncoding Settings page and select “0: Pass all frames or PassI-frames” option from the Filtering (Normal/Triggered) pull-down menu.Select “SNMP” option2. Go to the --> Confi guration/Contact Closure/Edit Contact ClosureSettings page, and set CC Output Mode to the “Group” and then select“SNMP” option from the Connection Type pull-down menu.Select “CCOUTPUT 1” optionSelect “CCOUTPUT 1” optionSelect “1: Pass all frames” or “1:Level sensitive trigger high” option3. Go to the --> Confi guration/Motion Detection/Edit Motion Detection andAction Settings page, and set Source to the “MD1”, select “CC OUTPUT1” option from the Target pull-down menu and select “1: Level sensitivetrigger high” option from the Action pull-down menu.Uploading JPEG files by contact closure input sensorIn this case encoder starts to upload JPEG files when CC input state is closed.Active checkbox must not be not selected!1. Go to the --> Confi guration/Pictures/Edit Picture Upload Settings pageand make sure that Active checkbox is not selected.Select “CC INPUT 1” optionSelect “JPEG 1” optionSelect “1: Level sensitivetrigger high” option2. Go to the --> Confi guration/Motion Detection/Edit Motion Detection andAction Settings page, and set Source to the “CC INPUT1”, select “JPEG1” option from the Target pull-down menu and select “1: Level sensitivetrigger high” option from the Action pull-down menu.68 MPX series video encoders user manual