XNX Universal Transmitter - Merkantile

XNX Universal TransmitterSelecting will reset alarms, faults or warnings generated by thesimulation. If the is selected, the simulation continues.CautionThe alarms and faults generated by the simulation will not be clearedfrom the XNX until alarms/faults are reset. Failure to reset the alarms/faults upon simulation exit, will keep the relays and LEDs in alarm/fault mode.2.6.2 ? Information MenuThe Information Menu Displays the current status information for thefollowing:Figure 2-127. Alarm/Fault Status ScreenThe ‘3’ is highlighted and selecting will reset all faults and alarmsgenerated by the XNX then return to the Alarm/Fault Status screen; ifthe user selects the switch, the display will also return to the Alarm/Fault Status screen.Date & TimeShow Alarm/Fault StatusShow Date/TimeShow Gas DataShow Range/Alarm Settings?Show Transmitter DataShow mA Level SettingsShow Transmitter StatusShow Relay SettingsShow Sensor DataShow Fieldbus Settings?Show Sensor Status ? Show Event HistoryAlarm/Fault StatusFigure 2-128. Date/Time ScreensThe Date and Time screens display the date and time in the formatscurrently set on the XNX. To set the time and date see Set Date &Time.Transmitter DataFigure 2-126. Alarm/Fault Status ScreenSelecting Alarm/Fault Status displays an Alarm Reset screen allowingfaults and alarms to be reset.Section 2 - Installation and Operation 2-47Figure 2-129. Transmitter Data ScreenUsing the switches, the Transmitter Data displays the ID, partnumber, serial number and revision level of the XNX firmware.2.6. Verifying the XNX Configuration